Electrix EQ Killer - Manual (Page 12)

Set-up 3: Post Mixer
This is a simple set-up for stereo processing of the entire mix.
Cueing is not possible with this setup, so use it only after exten-
sive experimentation with the EQ Killer. Send from the outputs
of your mixer to Input 1 of EQ Killer. Set the phono/line switch
for Input 1 to line. Use Output 1 to send to your amplification.
Note: Switching to Input 2 now acts as a bypass, it will not cut the
signal.
Set-up 4: Effect Loop Sends and your DJ
Mixer
Another simple technique is to connect the Stereo Effect Sends
of your EQ Killer to an extra input Channel on your DJ mixer.
This way, the "killed" bands will be available for fading and cross-
fading separately in your mix.
P Pe errffo orrm ma an nc ce e G Gu uiid de e