Electrix EQ Killer User Manual
Page 7
English... 7
Input 1/2 Select Switch:
This switch selects which of the
two signal paths is routed through the band killing circuitry of the
EQ Killer. If there is only one signal path through EQ Killer this
control will function like an effect bypass.
Q
QU
UIIC
CK
K S
ST
TA
AR
RT
T
• A
A
F
Fiirrs
stt
L
Lo
oo
ok
k
a
att
tth
he
e
C
Co
on
nttrro
olls
s
Band Level Controls:
Use these to adjust the volume of
each band. Band gain is at unity when the band level control is
returned to the notched position at 12:00.
Momentary & Band Kill Buttons:
The momentary but-
tons are used to "play" the band killing effect in time with the
music. The Band Kill buttons latch the Band Kill effect on or off.
When a Band Kill is latched on, its associated Momentary button
will turn it off and bypass the Band Kill effect.
LOW and HIGH X-Over Controls:
The X-Over controls
allow you to customize the width of each band on EQ Killer. The
LOW X-Over control sets the frequency transition point where
the LOW band ends and the MID band starts. The HIGH X-Over
control defines where the MID band ends and the HIGH band
starts.