Index, Flue damper models (figure 4) – American Water Heater GAS-FIRED COMMERCIAL WATER HEATER User Manual
Page 13
13
Flue Damper Models (Figure 4)
Model Designation
Clearances *
Capacity
Input
A
B
C
D
E
Sides and
Flue or
Ceiling
(GAL) (BTU/HR) (in.) (in.) (in.) (in.)
(in.) Rear
(in.)
Vent
(in.)
(in.)
80 180,000
71.88
66.25
64.38 56.00 55.13
2 6
20
80 199,999
(235,000 LP)
71.88 66.25 64.38
56.00
55.13
2 6
20
80 250,000
(235,000 LP)
71.88 66.25 64.38
56.00
55.13
2 6
20
98 199,999
82.88
77.25
75.38 67.00 66.13
2 6
20
98 250,000
(235,000 LP)
82.88 77.25 75.38
67.00
66.13
2 6
20
100 199,999
75.50
69.88
61.88 60.38 56.88
2 6
20
100 250,000
75.50
69.88
61.88 60.38 56.88
2 6
20
Model Designation
Clearances *
Capacity
Input
A
B
C
D
E
Sides and
Flue or
Ceiling
(Liters) (kW/hr) (m) (m) (m)
(m)
(m) Rear
(cm)
Vent
(cm)
(cm)
302.8 52.8 1.83
1.69
1.64
1.43 1.40
5.1
15.3
50.8
302.8 58.7
(68.9 LP)
1.83 1.69 1.64
1.43
1.40 5.1 15.3 50.8
302.8 73.3
(68.9 LP)
1.83 1.69 1.64
1.43
1.40 5.1 15.3 50.8
371.0 52.8 2.11
1.97
1.92
1.71 1.68
5.1
15.3
50.8
371.0 73.3
(68.9 LP)
2.11 1.97 1.92
1.71
1.68 5.1 15.3 50.8
378.5 52.8 1.92
1.78
1.58
1.54 1.45
5.1
15.3
50.8
378.5 73.3 1.92
1.78
1.58
1.54 1.45
5.1
15.3
50.8
The following notes apply to the tables accompanying Figures 1 - 4.
1. All models with flue dampers and/or above 400,000 BTU per hour
input employ a “spark” (IID) ignition system and requires 120 volt AC
electric supply.
2. * -Denotes minimum clearances to combustible material. Some
models may have different clearances. Check the label on the front of
the water heater to verify proper installation clearances.
3. Model number may have a suffix “N” for natural gas or “X”, “P” or “L”
for liquefied petroleum (LP) gases. Some models may have “A” as a
suffix or prefix. Check the rating plate on front of the water heater for
model number verification.
Installation continued-
Index