Hot Max Torches PL-40 - Manual (Page 8)

Note: A pressure regulator must be used with nitrogen gas from a cylinder.
 The pressure from the nitrogen gas cylinder to the PL-40 should never exceed 80 psi.
 Install a hose between the regulator and the PL-40 inlet.
Installation/Setup
Damaged Cylinders Can Explode.
Warning
 Keep cylinder upright and secured to a stable support.
 Keep cylinder clear of areas and items that could damage the cylinder.
 Be careful not to allow the cutting torch to touch the cylinder.
 Always keep the cylinder clear of electrical parts.
 Maximum pressure 80 psi.
KDAR Company
6
Assembly Instructions
1. Attached Brass fitting from Hose to Brass Fitting on
Machine, Tighten with Wrench, Once Air Pressure ap-
plied, check for leaks with Soapy Water.
2. Connect Red wire from gun using Black Knob on Ma-
chine.
3. Insert Plastic Fitting into machine and tighten plastic
nut.
4. Insert Ground Clamp connector and “lock” into place
by rotating clockwise.
5. Plug 220 Plug into standard Parallel Blade Receptacle,
NEMA 6-50R
6. Use Adapter included to use 110 Volt by plugging Ma-
chine into Adapter and 110 Volt Plug into 20 Amp Cir-
cuit
1.
2.
3.
4.
5.
6.