Asus T2-AE1 - Manual (Page 94)

5 - 3 0 5 - 3 0 5 - 3 0 5 - 3 0 5 - 3 0 C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p
5.5.6 5.5.6 5.5.6 5.5.6 5.5.6 Hardware Monitor Hardware Monitor Hardware Monitor Hardware Monitor Hardware Monitor
Hardware Monitor
CPU Temperature [51ºC/122.5ºF]
MB Temperature [41ºC/105.5ºF]
CPU Fan Speed [3813 RPM]
CPU Q-Fan Control [Enabled]
CPU Q-Fan Mode [PWM]
CPU Q-Fan Ratio [Auto]
Chassis Fan Speed [N/A]
Chassis Q-Fan Control [Enabled]
Chassis Fan Ratio [Auto]
VCORE Voltage [ 1.320V]
3.3V Voltage [ 3.345V]
5V Voltage [ 5.094V]
12V Voltage [11.880V]
CPU Temperature [xxxºC/xxxºF] CPU Temperature [xxxºC/xxxºF] CPU Temperature [xxxºC/xxxºF] CPU Temperature [xxxºC/xxxºF] CPU Temperature [xxxºC/xxxºF]
MB Temperature [xxxºC/xxxºF]
MB Temperature [xxxºC/xxxºF] MB Temperature [xxxºC/xxxºF] MB Temperature [xxxºC/xxxºF] MB Temperature [xxxºC/xxxºF]
The onboard hardware monitor automatically detects and displays the
motherboard and CPU temperatures. Select Disabled if you do not wish to
display the detected temperatures.
CPU Fan Speed [xxxxRPM] or [N/A] CPU Fan Speed [xxxxRPM] or [N/A] CPU Fan Speed [xxxxRPM] or [N/A] CPU Fan Speed [xxxxRPM] or [N/A] CPU Fan Speed [xxxxRPM] or [N/A]
The onboard hardware monitor automatically detects and displays the CPU
fan speed in rotations per minute (RPM). If the fan is not connected to the
motherboard, the field shows N/A.
CPU Temperature
Resume on PS/2 Mouse [Disabled] Resume on PS/2 Mouse [Disabled] Resume on PS/2 Mouse [Disabled] Resume on PS/2 Mouse [Disabled] Resume on PS/2 Mouse [Disabled]
When set to [Enabled], this parameter allows you to use the PS/2 mouse
to turn on the system. This feature requires an ATX power supply that
provides at least 1A on the +5VSB lead. Configuration options: [Disabled]
[Enabled]
Resume on RTC [Disabled] Resume on RTC [Disabled] Resume on RTC [Disabled] Resume on RTC [Disabled] Resume on RTC [Disabled]
Allows you to enable or disable RTC event to wake the system after a
power failure. Configuration options: [Disabled] [Enabled]