RME DSP System Multiface - Manual (Page 63)

User's Guide HDSP System Multiface II © RME
63
28. TotalMix MIDI Remote Control
28.1 Overview
TotalMix can be remote controlled via MIDI. It is compatible to the widely spread Mackie Control
protocol, so TotalMix can be controlled with all hardware controllers supporting this standard.
Examples are the Mackie Control, Tascam US-2400 or Behringer BCF 2000.
Additionally, the stereo output faders (lowest row) which are set up as Monitor Main outputs in
the Monitor panel can also be controlled by the standard Control Change Volume via MIDI
channel 1. With this, the main volume of the Multiface is controllable from nearly any MIDI
equipped hardware device.
28.2 Mapping
TotalMix supports the following Mackie Control surface elements*:
Element:
Meaning in TotalMix:
Channel faders 1 – 8
volume
Master fader Main Monitor channel's faders
SEL(1-8) + DYNAMICS reset fader to Unity Gain
V-Pots 1 – 8 pan
pressing V-Pot knobs pan = center
CHANNEL LEFT or REWIND
move one channel left
CHANNEL RIGHT or FAST FORWARD move one channel right
BANK LEFT or ARROW LEFT move eight channels left
BANK RIGHT or ARROW RIGHT move eight channels right
ARROW UP or Assignable1/PAGE+ move one row up
ARROW DOWN or Assignable2/PAGE- move one row down
EQ
Master Mute
PLUGINS/INSERT Master Solo
STOP Dim Main Monitor
PLAY Talkback
PAN Mono Main Monitor
MUTE Ch. 1 – 8
Mute
SOLO Ch. 1 – 8 Solo
SELECT Ch. 1 – 8 Select
REC Ch. 1 – 8 in Submix mode only: select output bus
F1 - F8
load preset 1 - 8
F9 select Main Monitor
F10 - F12 Monitor Phones 1 - 3
*Tested with Behringer BCF2000 Firmware v1.07 in Mackie Control emulation for Steinberg mode and with Mackie
Control under Mac OS X.