Kenwood KSC-SW01 - Manual (Page 5)

English
5
ENGLISH
SP.R
INPUT
＊
＊
SP.L
INPUT
Connecting the subwoofer to the subwoofer (non-fader) output of the center unit
Connect the subwoofer to the subwoofer output (non-fader
output) or the RCA jacks for the front output of the center
unit.
Notes:
• Read the instruction manuals for the connected components
such as the center unit as well as this instruction manual.
• Please purchase an RCA cord that is commercially available sepa-
rately.
• When the center unit incorporates a DSP, connect the subwoofer
to the subwoofer output (non-fader output) or to the RCA jacks
for the front output. Do not connect to the RCA jacks for the rear
output, as the low-frequency reproduction effect may be attenu-
ated due to the DSP effect.
KSC-SW01
7 Examples
The following shows a typical connection for effective car stereo enjoyment. Connect your system by referring to the example.
If there is no power control terminal in the center
unit, connect the blue/white wire to the accessory
line (ignition key switch ACC position line).
Center unit
(SUB WOOFER OUT,
Non-fader output)
Blue/White
Yellow Yellow
Fuse 10A
If buz zing noise is heard from the
speakers when the engine is running,
attach a line noise filter (commercially
available) to the power lead.
RCA cord
(Commercially
available parts)
When the center unit output is a single RCA jack, use an RCA cord that converts the output into the two RCA jacks as
shown above. The subwoofer output will be halved if the conversion cord is not used.
Caution:
Cover unused terminals
with insulation tape to
avoid short circuits.
4 10-pin
connector cord
Front speaker
Center unit
RCA cord
(Commercially
available parts)
Caution:
Under any circumstances, never
apply inputs to the hashed termi-
nals
A and B simultaneously.
Caution:
Connect the black lead wire ground terminal directly with a screw to an
unpainted metal part of the vehicle. Turning the power ON without con-
necting this terminal is linked to damage of the stereo system. Be sure to
connect it.
Also, painted metal panels etc., are not grounded and will not function
correctly. Be careful.
Battery
Car fuse box
(Main fuse)
Car fuse box
Ignition key
switch
RCA cord
(Commercially
available parts)
GND
B61-1344_EN.indd 5 B61-1344_EN.indd 5 09.5.28 11:53:18 AM 09.5.28 11:53:18 AM