A&D Wireless Automatic Blood Pressure Monitor UA-851ANT - Manual (Page 8)

E-4
Y ou must install 4 type AA (1.5 volt) batteries (included), or use the optional AC
Adapter (see page E-10 for instruction on using the monitor with the optional AC
adapter) and attach the cuff to the monitor before using it. To install batteries (or
replace them if the “Low Battery” symbol appears on display), proceed as follows:
1. Remove battery compartment cover by gently pushing down on arrow and sliding
cover forward.
2. Put in bottom row of batteries first. Place the batteries in
compartment with positive (+) and negative (–) terminals
matching those indicated in the compartment. Be sure
batteries make contact with compartment terminals.
3. Replace cover by sliding it into the compartment and
gently pressing into place.
4. Immediately place the monitor within 1 foot of an active receiver and hold in
place for 30 seconds to link the monitor to the receiver. If the link fails, remove the
batteries and repeat from step 1.
NOTE: This product is designed to work with different ANT wireless
solutions. Please refer to the ANT receiver for more detailed
instructions on linking the monitor to the receiver.
NOTE: Rechargeable batteries are not recommended.
GET STARTED
!
Step 1
Step 2
Step 3