Step 9 attach cables – American Megatrends MAN-758 User Manual
Page 29
Chapter 1 Hardware Installation
25
Step 9 Attach Cables,
Continued
J13 VGA Interrupt Enable J13 is a 2-pin berg that enables interrupt support for the onboard PCI
ATI VGA controller:
Onboard PCI ATI VGA Interrupt Setting
J13 Setting
PCI interrupt enabled for onboard PCI VGA.
OPEN
PCI interrupt disabled for onboard PCI VGA.
Shorted (Default)
J16 VGA Connector J16 is a 14-pin dual inline berg for the onboard ATI Rage II PCI VGA
controller. Connect the VGA cable supplied with this motherboard to J16. This
cable converts J16 14-pin berg signals to a standard DB15 VGA connector,
which can be mounted on the chassis. Make sure the red wire on the cable is
connected to Pin1 of J16. The pinout is:
Pin
Signal Description
Pin
Signal Description
1
Red
8
Ground
2
Green
9
Ground
3
Blue
10
Ground
4
VSYNC
11
Fuse
5
HSYNC
12
Ground
6
MONID1
13
Ground
7
MONID2
14
Pin is Cut
VGA Cable and J16 Connectors The following drawing illustrates the VGA connectors on the
VGA cable and J16 on the motherboard:
Cont’d