Kenwood DNX9260BT - Manual (Page 87)

DDX series DDX8026BT English 87
Next page 3 Next page 3
Crossover Network Setup
You can set a crossover frequency of
speakers.
1 Select the speaker to set the
crossover
2 2 2
1 1 1
3 3 3
4 4 4
1 Sets the High Pass Filter of the center
speaker. (DNX9/ DDX8 series)
2 Sets the High Pass Filter of the front
speaker.
3 Sets the High Pass Filter of the rear
speaker.
4 Sets the Low Pass Filter of the
subwoofer.
2 Display the Crossover setup screen
3 Set the crossover
[Phase] Sets the phase of subwoofer
output.
The phase is reversed 180 degrees
when set to "Reverse". (Only when
"Subwoofer" is set to any item other
than "None" in Speaker Setup)
[HPF FREQ] High Pass Filter adjustment.
(When front, center or rear speaker is
selected on Speaker Select screen)
[LPF FREQ] Low Pass Filter adjustment.
(When Subwoofer is selected on
Speaker Select screen)
[Slope] Sets a crossover slope.
Car Type (DTA) Setup Car Type (DTA) Setup
You can setup the car type and speaker
network, etc.
1 Display the Car Type Setup screen
Touch [ ] > > [ ] > > [Audio SETUP]
> > [Car Type]. (page 68)
2 Setup the Car Type
If your car type is selected, the Digital
Time Alignment and Equalizer is set
automatically (for timing adjustment of
sound output for each channel) to have
the highest surround effects.
1 1 1
1 Sets up the car type you use together
with this unit.
You can choose according to type of
your car.
"OFF", "Compact", "Sedan", "Wagon",
"Minivan", "SUV", "Passenger van"
[Location] Sets the locations of the
speakers.
[Adjust] Displays the Car Type Adjust
screen.
You can adjust the digital time
alignment that was set automatically
when you selected the car type.
B64-4676-00_01_E_English.indd 87 B64-4676-00_01_E_English.indd 87 10/02/05 15:27 10/02/05 15:27