Kenwood DPX504U - Manual (Page 12)

12 | Quick Start Guide
Connecting Wires to
Terminals
Installation/Removing the Unit
Installation
Bend the tabs of the mounting sleeve
with a screwdriver or similar utensil
and attach it in place.
⁄
• Make sure that the unit is installed
securely in place. If the unit is unstable, it
may malfunction (for example, the sound
may skip).
Removing the hard rubber frame
1
Engage the catch pins on the removal
tool 2 and remove the two locks on the
lower level.
Lower the frame and pull it forward as
shown in the figure.
Catch
Lock
Removal tool (Accessory 2 )
Connecting the ISO Connector
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive.
Make sure to make the proper connections
to prevent damage to the unit.
The default connection for the wiring
harness is described in 1 below. If the ISO
connector pins are set as described in 2,
make the connection as illustrated.
Please be sure to reconnect the cable as
shown 2 below to install this unit to the
Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the
vehicle’s ISO connector is linked with
the ignition, and the A-4 pin (yellow) is
connected to the constant power supply.
A-7 Pin
(Red)
A-4 Pin
(Yellow)
Unit Vehicle
Ignition cable
(Red)
Battery cable
(Yellow)
2 The A-7 pin (red) of the vehicle’s ISO
connector is connected to the constant
power supply, and the A-4 pin (yellow) is
linked to the ignition.
A-7 Pin
(Red)
A-4 Pin
(Yellow)
Unit Vehicle
Ignition cable
(Red)
Battery cable
(Yellow)
B59-2055-00_00_2DIN_E_QSG.indb 12 11/01/19 15:00