Phottix Strato TTL for Nikon - Manual (Page 7)

7
INSTRUCTION MANUAL EN
Flashes connected to Phottix Strato TTL
receivers on the same channel will fire when
the transmitter test button is pressed.
3. Pressing the receiver Test Button will test
fire flashes or strobes connected to that
receiver.
For Wireless Shutter Release: See Using the
Strato TTL as a wireless shutter release below.
Status LED
1. The Status LED on the Strato TTL transmitter
will flash green once every 2 seconds while
the power is on and turn solid green upon a
half-press of the shutter button (on camera
or the Strato TTL transmitter being used as
a wireless shutter release). The LED will turn
red when sending a signal or taking a photo.
When idle, the Status LED will go out.
2. The Status LED on the Strato TTL receiver
will flash green once every 2 seconds while
the power is on and in standby. The LED
will turn red when a signal is received from
the transmitter and the connected flash or
camera is fired.
3. When the battery level is low,the Status
LED on the receiver will flash red once every 2
seconds.
Channels
1. The Strato TTL System has 4 transmission
channels: 1, 2, 3, 4.