AMICA OSC 5458 I EN - Manual (Page 7)

- switch „O” controls the lighting. Sliding it to the left switches the lighting on, while sliding
it to the right switches it off.
- switch „W” activates the hood’s motor. Sliding it to the left activates the motor’s series of
three operating settings. By adjusting this, the optimum rotation speed can be chosen for the
ventilator according to the user’s requirements and for the minimum noise level.
3. Maintenance.
Regular maintenance and cleaning of the hood will ensure it works well and does not break
down, as well as prolong its lifetime. Particular attention should be paid to replacing the
grease filters and carbon filters in line with the instructions.
3.1 Grease Filters
a) replacement
The (cloth) grease filters should be replaced at least once every
two months when the hood is used normally. The filters are
removed by releasing the safety catches (arrows – fig. 5), while
remembering to keep the pins secure manually. Remove the
holders D, which secure the filters (fig. 6), replace the filters and
then replace the holders and mesh.
Fig.5
3.2 Carbon Filter
a) action
The carbon filter (C fig. 6) is able to absorb odours right up
until it is saturated.
This filter is not included with the hood’s fittings and must
be purchased separately if the hood is to function as an
absorber.
It cannot be cleaned or recovered, and should be replaced at
least every two months, or more frequently if the hood is
used particularly intensively.
Fig.6
b) replacement
- remove the mesh A (fig 6) from the hood’s casing along with the grease filter B (fig 6) as in
pt 3.1,
- replace the carbon filter C which is on the grease filter B (fig 6),
- mount the grease filter along with the carbon filter back into the hood.
3.3 Lighting
The lighting system consists of a 40W bulb.
To change a damaged bulb:
a) Remove mesh „A” from the hood casing, (see pt 3.1 a)
b) Change the bulb using a piece of cloth or paper,
IO 00150 /2 7