Ashcroft 2089 Precision Digital Test Gauge - Manual (Page 14)

– 14 –
Step 1: Press the CONFIG key until the word ZERO
SP appears.
Step 2: Press ENTER.
Step 3: Enter user five digit password (PW). This is
the same password established to access
the CONFIG mode in the menu.
Step 4: Press the CONFIG key to select the
desired option.
Step 5: Press ENTER to finalize the selection.
Notes:
Selecting the DISAB feature does not disable the
CLEAR button on the keypad for the MAX/MIN fea-
ture. If the DISAB feature is selected, pressing the
ZERO button on the keypad will cause the display to
read DISAB for two seconds. The gauge will then
revert back to the unit of measure of the gauge. The
DISAB feature disables the zero feature of the gauge.
Zero Disable Feature:
This feature allows disabling the Zero/Clear button
on the keypad. It also allows for a zero tolerance of
either 5% (default) or 10% of the gauge range.
Step 1: Press the CONFIG key until the word ZERO
SP appears.
Step 2: Press ENTER.
Step 3: A prompt appears to enter PW (enter
password). The ZERO SP password is the
same password as discussed on page 10
and the heading CALIBRAT:, Gauge
Calibration. Follow the instructions on
page 10 to enter a password.
Step 4: Press the CONFIG key to select the zero
tolerance, either 5% or 10% of range, or
press the CONFIG key again and the word
DISAB appears. Press ENTER to select the
new default setting.
KEYPAD FUNCTIONS
I&M008 10080 Rev. E_layout 10/14/13 9:35 AM Page 14