Horner APG XLt OCS HE-GSM04 - Manual (Page 3)

MAN0829-02-EN Specifications / Installation
____________________________________________________________________________________________________________________________
2/6/2009
Page 3 of 3 ECN # 948
TECHNICAL SUPPORT
For assistance, contact Technical Support at the following locations:
Standoff Model used on
Preferred standoff, use
this if the I/O board has
the mounting holes.
Use this if the I/O board
does no have the
mounting holes.
Use this if the I/O board
does not have the
mounting holes and the
GSM module is Rev A-C
Add Support
Standoffs
from the kit.
Warning : Be careful when installing the
module to align the connector properly.
Mis-alignment will damage the module.
6 TECHNICAL SUPPORT
For assistance and manual updates, contact Technical Support at the following locations:
North America:
Tel: 317 916-4274
Fax: 317 639-4279
Web:
http://www.heapg.com
Email: [email protected]
Europe:
Tel: +353-21-4321266
Fax: +353-21-4321826
Web:
http://www.horner-apg.com
Email: [email protected]
Add the foam strip to the antenna
support as shown, on both sides and
across the top.
No part of this publication may be
reproduced without the prior
agreement and written permission
of Horner APG, Inc. Information in
this document is subject to change
without notice.