Horner APG SmartBlock User Manual
Page 5
MAN0980-01-EN
Specifications/Installation
10/29/2013
No part of this publication may be reproduced without the prior agreement and written permission of Horner APG, LLC. Information in this document is subject to change without notice.
Page 5 of 5
7. LED INDICATORS
SmartBlock I/O Modules provide diagnostic and status LED indicators
Diagnostic LED Indicators
Diagnostic LED
State
Meaning
MS
indicates fault status
of the Network
Solid Red
RAM or ROM test failed
Blinking Red
I/O test failed
Blinking Green
Module is in power-up state
Solid Green
Module is running normally
NS
Indicates fault status
of the Network
Solid Red
Network Ack or Dup ID test failed
Blinking Red
Network ID test failed
Blinking Green
Module is in Life Expectancy default state
Solid Green
Network is running normally
Status LED indicators
– The Power Status LED illuminates
GREEN
when power is applied to the module. There are I/O status
LED indicators for each of the Digital I/O points, which illuminate
GREEN
when the I/O point is ON.
8. INSTALLATION / SAFETY
WARNING: Remove power from the CAN port and any peripheral equipment connected to this local system before adding or
replacing this or any module
All applicable codes and standards should be followed in the installation of this product.
When found on the product, the following symbols specify:
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth) ground before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly recommended to fuse the voltage measurement inputs. Be sure to
locate fuses as close to the source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of fire and shock hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure indicates a defective condition that will not clear by
replacing the fuse.
WARNING: Only qualified electrical personnel familiar with the construction and operation of this equipment and the hazards involved should install,
adjust, operate, or service this equipment. Read and understand this manual and other applicable manuals in their entirety before
proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life.
All applicable codes and standards need to be followed in the installation of this product.
For I/O wiring (discrete), use the following wire type or equivalent: Belden 9918, 18 AWG or larger.
Adhere to the following safety precautions whenever any type of connection is made to the module:
• Connect the green safety (earth) ground first before making any other connections.
• When connecting to electric circuits or pulse-initiating equipment, open their related breakers.
Do not make connections to live power lines.
• Make connections to the module first; then connect to the circuit to be monitored.
• Route power wires in a safe manner in accordance with good practice and local codes.
• Wear proper personal protective equipment including safety glasses and insulated gloves when making connections to power circuits.
• Ensure hands, shoes, and floors are dry before making any connection to a power line.
• Make sure the unit is turned OFF before making connection to terminals. Make sure all circuits are de-energized before making connections.
• Before each use, inspect all cables for breaks or cracks in the insulation. Replace immediately if defective.
9. TECHNCIAL SUPPORT
North America
Tel: 1877-665-5666
Fax: 317 639-4279
Web
Email:
Europe
Tel: +353-21-4321266
Fax: +353-21-4321826
Web
Email: [email protected]
WARNING: Consult user documentation.
WARNING: Electrical Shock Hazard.