Matrix Orbital GLK240128-25 - Manual (Page 47)

42 Command Summary
11.6 Create a
Slider Dec
Hex
ASCII 254 186
FE BA
■ ║
ID Type X Y Width Height Control Width Min Max
ID Type X Y Width Height Control Width Min Max
ID Type X Y Width Height Control Width Min Max v8.3
Draw a slider on the screen that responds visually and numerically when tapped or slid. Slider regions respond
with a value of 83, their ID, then two byte length current X and Y coordinates when activated.
ID Byte Unique slider identification number, maximum 32 regions/sliders. value between 0 and
31
Type Byte Defines slider direction and starting point for the control, as below.
X Byte Leftmost coordinate.
Y Byte Topmost coordinate.
Width Short Width of slider.
Height Short Height of slider.
Control Width Byte Width of the slider control.
Min Short Minimum slider value.
Max Short Maximum slider value.
Table 35: Slider Definition
Value Description
16 Horizontal slider, starting at minimum position
17 Vertical slider, starting at minimum position
32 Horizontal slider, starting at maximum position
33 Vertical slider, starting at maximum position
64 Horizontal slider, starting at middle position
65 Vertical slider, starting at middle position
11.7 Delete a
Slider Dec
Hex
ASCII 254 189
FE BD
■ ╜
ID
ID
ID v8.3
Deletes a previously created slider. Memory is shared with touch regions, this command will free space.
ID Byte Unique region identification number.
11.8 Delete
All Sliders Dec
Hex
ASCII 254 190
FE BE
■ ╛
v8.3
Deletes all previously created sliders. Does not remove touch regions.
11.9 Set
Dragging
Threshold Dec
Hex
ASCII 254 137
FE 89
■ ë
Threshold
Threshold
Threshold v8.0
Sets the distance a press is required to travel before a drag event is reported. Precision will vary inversely to data
transmitted; care should be taken to find a suitable balance. Distance is calculated as
.
Threshold Byte Dragging threshold value. Default is 8.