Accton Technology SIP Gateway VG3300 Series - Manual (Page 35)

3. If the number is not in dialing plan, the call will be sent to PSTN.
Phone Book Call: Dial <#>+ <index>+<#>.
1. Compare SIP Phone books; check the number if it is in phone book.
2. If the number is configured in Phone Book and Proxy selection is set to "No", you will hear a
busy tone. If Proxy selection is set to "Yes", then send the call to proxy.
3. If the index number you had configured to use Via Proxy but it communicates with proxy failed,
you will hear busy tone.
4. If the number is not in phone book, you will hear busy tone.
Force PSTN Call: Dial <*>+<numbers>.
Always go through PSTN
Hotline Call:
If the channel is configured to use Hotline function, any dialing above is disabled. If the channel is
hotlined to other SIP device, no dialing is needs after user picks up handset. Other SIP device rings
immediately.
Hotline Call to VES3302:
Dial <SIP extension number> or
<Prefix number (configured in VES-3302 Line)>
1. If you dial SIP extension number, other SIP device that register to VES-3302 Line with that SIP
extension number will ring.
2. If you dial Prefix number, the call is relay to the IP-PBX network according to the Prefix Map
specified in VES-3302 Line.
Notice: If you do not want to dial “#” after numbers, please configure the ‘Dial Ending
Time’ item. After the seconds, the call will be sent automatically.
WEB Page: ADVANCED\GENERAL
10.9. Make Inbound Transit Call
To make an inbound transit call from PSTN to SIP, you have to enable Auto Answer function of this
gateway
32