ROHM BOF - BSS drilling machine vice - Manual (Page 7)

2
4.5. Clamping with clamps in side face
(possible on both sides)
4.3.2 Mounting with 2 screws for T--slot 12 mm
and 14 mm (included in delivery)
4.4. Clamping with clamps
(for series works)
4.3. Clamping with guiding rail
4.3.1 Mounting in spacer disk
S Swivel bearing, free position
S Safety and guard against catching and lift
off of the vice
4.2. Clamping with clamps
4. Mounting the BOF and BSS machine vices
S Check machine table and base of vice for un-
evenness and microchips and remove these if
detected.
S Do not mar the finish of the vice.
S Make sure that the entire bottom face of the vice
rests flat on the machine table.
S Distribute the fastening elements so that the re-
sulting connection between machine table and
vice is as rigid as possible.
S There are slots for mounting (see 4.1 -- 4.2)
BSS
only “Slim Design”
4.1. Mounting with bolts (having at least
a class 8.8 strength)