AAMP of America Peripheral Simple iPod Interface for BMW - Manual (Page 7)

Symptom Cause Remedy
No Power Blown fuse in vehicle fuse
block.
Replace fuse with same
amp rating. If the fuse
blows again, call tech
support.
No Power Bad connection Check cable and wiring
connection.
Alternator noise is heard
(Changes with Engine RPM)
Improper wiring creates a
ground loop
Install a Ground loop isola-
tor or seek professional
service from a local car
audio shop.
You can hear music from
the iPod but you cant con-
trol it from the radio.
The Firmware on the iPod
may not be updated.
Update the Firmware on
the iPod. See section 1.2
of this manual.
Radio is not recognizing
iSimple BMW interface
Bad cables or cables are
not connected properly
between converter box and
car radio
Check connection and
cables, push in firmly.
Radio is not recognizing
iSimple BMW interface
Wrong configuration on the
interface
Select the right pconfigu-
ration for your car. (See
section 1.5)
iPod Audio is Low or
Distorted
iSimple BMW interface is
connected with an external
CD changer or other exter-
nal factory audio source
Disconnect the factory
external audio source.
For consumer technical support call:
866-788-4237 in the US or 727-572-9255 ext.262 for international calls
Hours: 9:30 am-6:00 pm E.S.T. MON - FRI
3.2 Trouble Shooting
5