Specifications, 1 raven100 specifications, Configuration – Campbell Scientific Raven100 CDMA Cellular Modem User Manual

Page 6: 1 base station requirements for raven100

Advertising
background image

Raven100 CDMA AirLink Cellular Modem

What you receive from Verizon:

10-digit Mobile Directory Number (MDN)
Mobile Identification Number (MIN)
System Identification Number (SID)
IP address (for a Static IP account only)

The MDN and MIN are typically the same number, but make sure you get both
numbers.

3. Specifications

3.1 Raven100 Specifications

AirLink Raven100 models C3210, C3211

RF Output: 224 mW (+23.5 dBm)

CDMA Modes Supported: CDMA2000 1X, IS-95B Circuit Switched CDMA,

and SMS

Dual-band Support: 800 MHz cellular, 1.9 GHz PCS bands

Packet Mode (1xRTT) Data Rates: up to 153.6 kbps (forward channel),

76.8 kbps (reverse channel)

RS-232 Data Rates: 1200 bps to 115.2 kbps

Input Voltage: 10 to 28 Vdc

Input Current: 50 to 250 mA

Typical Current Drain at 12 Vdc: 40 mA dormant connection (idle for 10 to 20

seconds), 200 mA while receiving, ~200 mA during transmission

Operating Temperature Range: -30° to +70°C (10% duty cycle limit above

60°C)

Operating Humidity: 5% to 95% non-condensing

Serial Protocols: AT Commands, PPP, SLIP, UDP, TCP

Serial Interface: RS-232, DB-9F

RF Antenna Connector: 50 Ohm TNC

Status LEDs: Power, Channel Acquired, Link Status, Network Registration,

RSSI, Transmit/Receive, Block Errors

Dimensions: 3"W x 1"D x 5.1"L (5.8"L w/connector), 7.6 W x 2.5 D x

13 L cm (14.7 L cm w/connector)

Weight: < 1 lb (<0.5 kg)

4. Configuration

4.1 Base Station Requirements for Raven100

PC running Campbell Scientifics’ LoggerNet or PC400 software, with access
to the internet.

2

Advertising