Campbell Scientific UT10 10 foot Tower w/ Grounding Kit and Hinged Base - Manual (Page 48)

UT10 Weather Station
8.5.8 HC2S3 Rotronic Temperature and RH Probe
Mount the probe inside the 41003-5 10-plate radiation shield as shown in
FIGURE 8-19.
1. Insert the 27731 hex plug that ships with the HC2S3 probe into the
underside of the 41003-5 base.
2. Insert the probe into the radiation shield leaving about 2.5 cm (1 in)
exposed below the hex plug.
3. Tighten the hex plug such that it compresses against the body of the
HC2S3 to hold it inside the radiation shield.
4. Attach the probe to the cable by aligning the keyed connectors, pushing
the connectors together and tightening the knurled ring.
FIGURE 8-19. HC2S3 Temperature and RH Probe
41003-5
pn 27731 Hex Plug
U-bolt
CM200 Series Crossarm
38