Tamerica Products TCC-1200 - Manual (Page 4)

common temperature/speed setting for typical uses. Wait another 10 ~12 minutes before starting the
lamination job.
Film Thickness Temperature Speed
1.5 Mil (38 Micron) 110°C (230°F) 3
3 Mil (75 Micron) 115°C (239°F) 4
5 Mil (125 Micron) 125°C (266°F) 2
10 Mil (250 Micron) 150°C (302°F) 2
LAMINATING PROCEDURES
1. Release the handle from the locked position and insert the handle pin into the “MIN” notch to
engage the rollers. The user can now start laminating as the machine starts feeding in film.
2. To put the lamination temporarily on hold without turning off the machine, the user can release
the handle and reinsert in any of the notches from 3/16” and higher. This will separate the rollers
and stop the motor from feeding more film.
3. Pull the handle back to the “MIN” setting to reengage the rollers and resume the lamination job.
(2) ONE-SIDED LAMINATION
LOADING THE FILM
Unpack only the upper rod. Install nylon or thermal film on 1” or 3” cores by following an
adapter---film----adapter sequence onto the rod and fit the adapters onto the paper core. Leave equal
lengths of the rod out of each end. Use the guide to position the roll of film then tighten the screw on
the adapter to secure the roll film. Load the rod on the laminator.