Tamerica Products TCC-1200 - Manual (Page 9)

needed to be set for this application. Simply remove the liner from the board, carefully and
evenly align the print and set it onto the adhesive side. The pressure applied by the rollers
will enhance adhesion of the print onto the board. Please refer to instructions on how to
apply prints on these types of boards that come with their packaging or consult with the
mounting board supplier.
e. For simultaneous mounting and cold laminating using cold films with liners, set the machine
up for COLD LAMINATION.
2. As soon as the user has set up the machine, simply align the print evenly onto the board, release
the handle from the locked position and pull towards the desired notch based on the thickness of
the board being used. Insert the handle pin into the notch to lock the handle in position.
3. Align and press the board between the rollers evenly using the guide plates and step on the foot
pedal to start feeding and mounting. Keep your foot on the pedal as long as you need to do
mounting. When the mounting job is done or when taking a break, release the pedal to stop the
feeding as soon as the last board is all the way through the back of the machine.