Airlink Raven II - Manual (Page 12)

AirLink Raven II CDPD Modem
Page 8 AirLink Communications, Inc.
16. Select the Connection tab and set the Connection Preferences to:
Data bits: 8
Parity: None
Stop bits: 1
Uncheck (disable) “Wait for dial tone before dialing.”
17. Select Port Settings. You should see the Advanced Port Settings
dialog. Check the box for Use FIFO buffer if appropriate. If the
button is enabled, it is probably appropriate.
18. Select OK. You should go back to the Connection tab.
19. Select Advanced. You should see the Advanced Connection Settings
dialog.
20. Set Use Flow Control and Hardware, then select OK. Only
hardware flow control is available.
21. Select OK on the "AirLink CDPD Modem Properties" dialog box.
22. Select Close on the "Modem Properties" dialog box.
2.2.2 Creating the PPP Connection
This section details the configuration of the Windows Dial-Up Networking
PPP Connection.
1. Select Start→ → → →Settings→ → → →Dial-Up Networking.
If Dial-Up Networking is not installed, please go to Control Panel→ → → →
Add/Remove Programs→ → → → Windows Setup→ → → → Communications→ → → →
Dial-Up Networking and check the box next to it. During this
installation, you may be prompted for your Windows CD and have to
reboot afterwards.