Airlink Raven II - Manual (Page 25)

User’s Manual
AirLink Communications, Inc. August 9, 2001 Page 21
3. Hardware Installation
This section details the hardware specs of the Raven II and mounting it with
other hardware, the power requirements, mounting bracket, etc.
3.1 Mounting the Raven II
The Raven II should be mounted in a position that allows easy routing and
access for the cables. There should be no binding or sharp corners in the cable
routes. The Raven II should be mounted so that the LEDs on the front panel
can be easily seen for ease of operational verification.
The snap-in mounting bracket (part number 100-170-1006) is installed using
#8 or #10 screws. Press the Raven down firmly into the bracket and note that
both sides have locked into the groove on the Raven II case.
Figure 1 - Raven II Mounted in Mounting Bracket
Note: The tie-wrap is if the modem needs to be really secure, as in a vehicle
or in shipping. In stationary applications, as in a box that sits out in a
pasture with a solar cell, etc., the tie-wrap is not necessary.