Samsung RSH7PNPN - Manual (Page 10)

10_ setting up
Reattaching the Fridge Door
1. Insert the lower hinge 1 back into the lower
hinge bracket 2 .
2. Fit the hole in the corner of the fridge door 3
over the lower hinge 4 .
3. Insert the upper hinge shaft 5 into the hole
on the hinge 6 . Make sure the hinge is level
between the upper hinge hole 7 and the hole on
the top of the cabinet 8 . Then, reattach hinge
screws 9 and the ground screw 10 by turning it
in a clock wise direction.
4. Place the front part of the upper hinge cover 11
on the front of the upper hinge 12 and reattach it
with the screw.
Reattaching the Water Supply Line
1. Insert the water line 2 into the coupler 1 .
2. The Water Line must be fully Inserted to the center
of transparent coupler to prevent water leakage
from the dispenser.
3. Insert the 2 clips in the install pack and check that
each clip holds the line fi rmly.
Do not cut the water line. Gently separate it
from the coupler.
Reattaching the Front Leg Cover
Before attaching the cover, check water
connector for leakage.
Replace the front leg cover by turning the three
screws clockwise, as shown in the fi gure.
1
2
3
4
12
11
1
2
Center of transparent Center of transparent
coupler coupler
clip A (1/4”) clip A (1/4”)
(6.35mm)
(6.35mm)