Checking the water dispenser line (optional), Using the ice maker (optional), Installing the water dispenser line – Samsung RSH7PNPN User Manual

Page 12: Normal operation, Connecting to the water supply line

Advertising
background image

12_

setting up

CHECKING THE WATER
DISPENSER LINE (OPTIONAL)

A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that. In order for the icemaker to operate properly,
water pressure of 138 ~862 Kpa is required. Under
normal conditions, a 170 cc paper cup can be fi lled
in 10 seconds. If the refrigerator is installed in an area
with low water pressure (below 138 Kpa), you can
install a booster pump to compensate for the low
pressure. Make sure the water storage tank inside
the refrigerator is properly fi lled. To do this, press the
water dispenser lever until the water runs from the
water outlet.

Water Line installation Kits are included. You can
fi nd it in one of the freezer drawers.

USING THE ICE MAKER (OPTIONAL)

To Remove the Ice Bucket

- Hold the handle as shown in fi gure1.
- Slightly pull up the bottom part.
- Take out the ice bucket slowly.

To Refi t The Ice Bucket

- Assemble it in the reverse

order of disassembly.

- Push the bucket in fi rmly until

you hear a clicking sound.

- When the bucket does not fi t

into its place, turn the gear
handle on its back by 90
degrees and reinstall it again
as shown in fi gure 2.

Normal Operation

- Any sounds you hear when

the ice maker dumps ice into
the bucket are part of normal
operation.

- Not dispensing ice for long

periods may cause ice
clumps in the ice bucket.
Remove the remaining ice
and empty the bucket.

- When ice does not come

out, Check for any ice stuck
in the chute and remove it.

- The fi rst batch of ice cubes may

be small due to air in the pipe
after connection, any air will be
purged during normal use.

- When ICE OFF blinks on the display panel,

reinsert the bucket and/or make sure it’s
installed properly.

- When the door is open, the Ice and water

dispenser do not work.

- If you close the door hard, it may cause

water spilling over the ice maker.

- To prevent dropping the ice bucket, use

both hands when removing it.

- To prevent injury, be sure to clean up any

ice or water that may have dropped on
the fl oor.

- Do not let children hang on the ice dispenser

or on the bucket.
They may get hurt.

- Be sure not to put your hand or any object

into the ice chute.

It may cause personal injury or damage

mechanical parts.

INSTALLING THE WATER
DISPENSER LINE

For Interior model
Parts for water line Installation

Connecting to the water supply line

1. fi rst, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in the
installation kit.

Figure2

Ice Chute

Ice Chute

Figure1

CAUTION

CAUTION

The water line must be connected

to the cold water pipe. If it is connected

to the hot water pipe, it may cause the

purifi er to malfunction.

1

Water line fi xer and screws

2

Pipe connector

3

Water line

4

Clip

5

Water Filter

Advertising
This manual is related to the following products: