Actiontec electronic UP102 - Manual (Page 19)

16
Actontec VoSKY Call Center User Manual
Dual-Lne Connecton wth DSL Modem
Since DSL modems are connected via phone line (like Call Cen-
ter), there are two ways to connect Call Center when a DSL mo-
dem is present: Connecting to a Phone Line Splitter, and Connect-
ing to a DSL Filter. Select the configuration matching the current
computer/DSL set up, and follow the instructions.
Connecting to a Phone Line Splitter
If the telephone is connected to the phone line via a phone
line splitter, follow this procedure to connect Call Center:
1. Use the supplied phone cable and insert it in the “Line” port of
Call Center.
2. Insert the other end of the supplied phone cable in the micro-
filter.
3. Get the phone cable from the telephone and insert one end in
the “Phone” port on the rear panel of Call Center.
4. Connect the other end of the phone cable to the telephone. The
components should be connected similarly to the figure below:
Call Center is connected in Dual-Line mode. Next, go to chapter 4,
“Installing Call Center Software.”
d