ASKO W6641 W661 - Manual (Page 4)

Page 4
Height 33-1/2”–34-1/2 (850–876 mm)
Width 23-7/16” (595 mm)
Depth W6641/W6661: 23-7/16" (595 mm)
W6021/W6221: 24-7/16” (620 mm)
Weight 167 lbs. (73 kg)
Rated load See data plate
Supply voltage Single-phase 230 V, 60 Hz
Heating element 2000 W
Fuse 15 A (2 internal fuses)
ACCESSORIES ACCESSORIES
INST INSTALLA ALLATION INSTR TION INSTRUCTIONS UCTIONS
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections. IMPORTANT NOTE:
Cosmetic damage must be reported to your dealer
within five days from the date of purchase. After
unpacking the washer, thoroughly check the unit for
cosmetic damage.
SPECIFICA SPECIFICATIONS TIONS
Drum and Barrel Stainless steel
Outer casing Stove-enamelled hot-dipped
galvanized steel or stainless steel
Mounting Four adjustable rubber-covered
feet
Inlet supply hose 5 ft. (1.5 m) PEX tubing with
brass ferrules
Supply pressure 15–142 PSI
Outlet hose 5.5 ft. (1.7 m) polypropylene hose,
3/4” ID
Be sure to tighten the
lock nuts securely
when you level the
machine.
REMO REMO VING VING THE SHIPPING THE SHIPPING
SUPPORTS SUPPORTS
The machine is transported with three shipping
supports, as illustrated below. These supports hold
the tub in place during shipment. When you unpack the
machine, you must remove these supports.
To remove the shipping supports, follow the instructions
below:
1. Unscrew the 5/8” (12
mm) bolts holding the
supports in place and
remove the bolts.
2. Push the rubber spacer
up then pull it out of the
slot.
3. Rotate the spacer so that
the extruded end points
toward the machine.
4. Insert it into the slot and
push down to lock it into
position.
Cold water
supply
Tap
You must remove the
shipping supports
before you install the
washer.
LEVELING LEVELING THE MA THE MACHINE CHINE
It is important that the machine is level so it won’t vibrate
excessively during the spinning cycles. Each foot on
the washer is adjustable, so you can level the washer
on any surface. Once it is level, securely tighten the lock
nuts on the feet to prevent excessive vibration during
the spin cycles.
WA WATER SUPPL TER SUPPLY CONNECTION Y CONNECTION
Because ASKO washers have their own heating element,
you only need to have a cold water inlet. The connection
should be made by someone who is sufficiently skilled.
Use the hose supplied with the washer.
Water pressure must be in the range of 15–146 PSI.
A tap should be fitted on the water supply pipe.
If a new supply pipe has been installed for the washer,
it should be flushed thoroughly to remove any foreign
particles that might clog the strainer in the water inlet.
NOTE: If unit is installed on a second story, follow
local building codes. We recommend a drip
pan be installed.