Aga Ranges U107501-01 - Manual (Page 36)

36
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Checking the parts
Check that the range has the following parts.
Leveling tool & Allen keys Broiler pan and trivet
Meat tin Handyrack
3 Main oven racks Tall oven racks & rack
supports
Splashback & Plinth Rear spacer
anti tip device kit
Miscellaneous parts pack
(rear spacer end caps, fi xings,
ground strap ect.)
Leveling the Range
Place the range in its intended position taking care
not to twist it within the gap between the kitchen
units as damage may occur to the range or the
units. Install the oven shelves in the oven. Check for
levelness by placing a spirit level or a cup, partially
fi lled with water, on one of the oven grids. If using a
spirit level, take two readings-with the level placed
diagonally fi rst in one direction and then the other.
The front feet and rear rollers can be adjusted to
level the range. To adjust the height of the rear of
the range use the leveling tool supplied to turn the
adjusting nuts at the front bottom corners of the
range. To set the front feet turn the bases to raise or
lower.
Anti-Tip Device
WARNING
Range must be secured by the Anti-Tip bracket
supplied. See instructions to install (supplied with
bracket). Unless properly installed, the range could
be tipped by leaning on the door. Injury might
result from spilled hot liquids or from the range
itself.
Installing the Anti-Tip Device
The Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions and the instructions that fi t your
situation before beginning installation.