Samsung VCC96P0H1G-XAA - Manual (Page 8)

08_ operating the vacuum
VACUUMING WITH THE POWER BRUSH
OVERLOAD PROTECTOR
1. Attaching the Power Brush
The hose must be plugged into the canister and the
power brush must be plugged into the hose and
extension wand.
2. Vacuuming
• For best results, move the power brush slowly using
short, overlapping strokes.
• For heavily soiled areas, repeat strokes in several
directions.
• Push the height adjustment button to match the surface being cleaned.
• Press the height adjustment button at the bottom of the wand until it clicks.
Do not invert the power brush while it is running.
3. Checking the Performance of the Power Brush
You can check whether the power brush is operating correctly by lifting up the
extension tube slightly to view the back of the brush.
The Power Brush will not operate when it is jammed or the unit is turned off.
If the Power Brush is jammed, unplug the power cord from the electrical outlet.
Turn the power brush over and remove the jammed object.
Turn the power brush back to the vacuuming position and resume vacuuming.
The overload protector shuts off the brush motor
if the floor brush becomes obstructed. The floor
brush will stop, but the suction motor will continue
to run. To reset the overload protector, turn the
vacuum off and unplug it. Clear the obstruction from
the floor brush area. Use a pen tip to press down
the reset switch. Turn the vacuum on and continue
cleaning.
CAUTION
Reset S/W
POWER BRUSH
DJ68-00621J-03.indb 8 13. 7. 31. �� 11:34