Samsung SC-D353-XAP - Manual (Page 25)

ENGLISH
Preparation
21 21
Using the Lithium Ion Battery Pack
✤ The amount of continuous recording time available depends on
- The type and capacity of the Battery pack you are using.
- How often the zoom function is used.
It is recommended that you have several batteries available.
1. Attach the Battery pack to the Camcorder.
2. Connect the AC Power adapter to an AC Cord and connect the AC Cord to
a wall socket.
3. Connect the DC cable to the DC jack socket on the Camcorder.
4. Turn the Power switch to Off, and the charging indicator will start to flash,
showing that the battery is charging.
5. When the battery is fully charged, disconnect the Battery pack and the AC Power adapter from
the Camcorder.
Even with the Power switched Off, the Battery pack will still discharge.
[ Notes ]
■ The Battery pack may be charged a little at the time of purchase.
■ To prevent reduction in the life and capacity of the Battery pack, always remove it from the Camcorder after it is fully charged.
■ The amount of continuous recording time available depends on:
- The type and capacity of the Battery pack you are using.
- How often the zoom is used.
- Type of use (Camcorder/Camera/With LCD screen etc.).
- Ambient temperature.
It is recommended to have additional battery packs available.
■ Even when the Power switched Off, the Battery pack will still discharge if it is left attached to the device.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90% ~ 100%
On for a second and Error - Reset the Battery pack and
off for a second the DC cable
Power Switch
Charging the Lithium Ion Battery Pack
4
<Charging indicator>