Samsung SPH-A303ZDASKE - Manual (Page 9)

Section 1: Getting Started 9
Activating Your Device
2. Replace the battery cover (1) and slide it toward
the bottom of the phone (2) until the cover clicks
into place.
3. Make sure that the battery is properly installed
before switching on the phone.
Turn Your Device On
1. Open the slide on your device.
2. Press and hold the key for two or more seconds.
Note: As with any other radio-transmitting device, do not touch the antenna (located at the top of the battery
compartment) while using your device as this can affect call quality and can cause the device to operate at a higher
power level than is necessary.
3. The device begins searching for a network signal.
4. Once the device finds a signal, the current time displays on the upper, right side of
the icon bar.
5. You’re now ready to place and receive calls.
Note: If you are outside of your carrier’s coverage or roaming area, the No Service icon ( ) appears at the top of the
device’s display. If you cannot place or receive calls, try later when service is available, or at another location.
Turn Your Device Off
Ⅲ Press and hold the key for two or more seconds. Your device powers off.
Note: If your device is on and you press for less than one second, the device will not power off. This prevents your
device from being turned off accidentally.
Remove the Battery
Important! You must unplug the Travel Adapter (if it is connected) before removing the battery from the device during
charging to avoid damage.
If necessary, switch off the phone by holding down the key until the power turns off.
1. Remove the battery cover by sliding the battery cover in the direction of the arrow.
2. Carefully lift the battery cover away from the
bottom of the phone.