E. connecting ductwork for outside top, Exhaust, Step-by-step installation guide – Samsung SMH1713W-XAA User Manual

Page 17: D. mount the microwave oven, D. mount the microwave oven (cont.), E. connecting ductwork for outside top exhaust

Advertising
background image

16

Step-by-step installation guide

17

Step-by-step installation guide

D. mOUNT THE mICROWAVE

OVEN

FOR EASIER INSTALLATION AND PERSONAL

SAFETY, WE RECOMMEND THAT TWO PEOPLE

INSTALL THIS MICROWAVE OVEN.

ImPORTANT: Do not grip or use handle during

installation.

NOTE: If your cabinet is metal, use the nylon

grommet around the power cord hole to prevent

cutting of the cord.

NOTE: Filler blocks are required when mounting this

unit under any cabinet with a recessed bottom or

front overhang. (See page 9.)

ImPORTANT:The case damage that will occur

from over tightening screws when filler blocks

are not used is not covered under warranty.

NOTE: When mounting the microwave oven, thread

power cord through hole in bottom of top cabinet.

Keep it tight throughout Steps 1–3. Do not pinch

cord or lift oven by pulling cord.

1. Lift microwave, tilt it

forward, and hook slots

at back bottom edge

onto four lower tabs of

mounting plate.

3. Insert a self-aligning screw through top center

cabinet hole. Temporarily secure the oven by

turning the screw at least two full turns after

the threads have engaged. (It will be completely

tightened later.) Be sure to keep power cord

tight. Be careful not to pinch the cord,

especially when mounting flush to bottom

of cabinet.

D. mOUNT THE mICROWAVE

OVEN (CONT.)

Equivalent

to Depth of

Cabinet Recess

Cabinet Bottom Shelf

Microwave Oven Top

Cabinet Front

Filler Block

Self-Aligning Screw

4. Attach the microwave oven to the top cabinet.

5. Insert the 2 self-aligning screws

through the cabinet bottom shelf and

filler block into the outer top cabinet

of the unit. Continue to support the

unit until both screws are inserted and

engaged at least two full turns, then

fully tighten both screws until the unit

is secure.

6. Install grease filters. See the Owner’s Manual

packed with the microwave.

E. CONNECTING DUCTWORK

FOR OUTSIDE TOP

EXHAUST

House Duct

1. Extend the house duct down to connect to the

exhaust adaptor.

2. Seal exhaust duct joints using duct tape.

SMH8165_XAA DE68-03587A-04-EN_120725.indd 17

2012-07-25 �� 8:05:32

Advertising