Samsung SCH-I920DAAVZW - Manual (Page 139)

134
– Tap New Outgoing Port to choose a device and set up a new
outgoing port.
• Dial Up Network Terminal: No configurable settings.
• Basic Printing: No configurable settings.
• File Transfer: Tap Options for these settings:
– Tap Enable to write to enable/disable writing to your device.
– Tap Shared Folder to choose a location on your device for sharing.
• Object Push: Tap Options for these settings:
– Tap Enable to receive all Incoming to enable/disable automatic
receiving for incoming beams.
– Tap Shared Folder to choose a location on your device for sharing.
• Human Interface Device: No configurable settings.
• Phonebook Access: No configurable settings.
9. Tap Menu ➔ Device Info for settings about your device:
• Tap Device Name to modify your device’s name, to be using during
pairing.
• View the MAC address, which is needed for some pairings.
• Enable visibility to other devices to put your device in discoverable
mode, visible to other searching Bluetooth devices.
• If in discoverable mode, tap Turn off Visible Mode to set a length of
time to remain discoverable. Choose from Never , After 1 Minute ,
After 5 Minutes , or After 10 Minutes .
Note: The Device Name that appears on the above screen can also be
changed via the Owner Information Settings. For more information, see
“Owner Information” on page 95.
Bluetooth Bonds
A bond is a relationship that you create between your Omnia II
and another Bluetooth-enabled device to exchange information in
a secure manner. Creating a bond involves entering the same
Passkey on the two devices sharing a bond.
Bonds are created only once between devices. Once a bond is
created between devices, the devices do not have to be
discoverable to exchange information; however, each device
must have its Bluetooth radio on.
Creating Bluetooth Bonds
Note: Make sure that the two devices are within range of one another and
that Bluetooth discoverable mode is enabled on both devices.
1. Press the Main Menu key , Main Menu 2 ➔
Bluetooth .
– or –
Press the Main Menu key , then Settings ➔
Basic Settings tab ➔ Bluetooth Settings.
2. Turn on Bluetooth by tapping the blue device icon.