Samsung SCH-I920DAAVZW - Manual (Page 146)

Changing Your Settings 141
off device to cause the phone to turn off after a specified time interval,
and set the interval. Tap the Done soft key when finished.
– External Power: Tap Turn on backlight to enable the backlight when
a button is pressed. Tap Turn off backlight to disable the backlight
when not used for a specified time interval, and set the interval. Tap
Turn off device to set a time interval for automatic shutoff, and set the
interval. Tap the Done soft key when finished.
– Brightness: Use the slider bar to increase or decrease the display’s
brightness. Tap the Auto adjustment option to auto-adjust based on
available light. Tap the Done key when finished.
– Performance: Set the CPU Performance for the device.
• Buttons: Select functions for some of the phone’s buttons.
– Assign a program: Assign a program to the designated buttons. Tap
Button1, Button1 Hold, Button2, and Button2 Hold to assign a
program for each button. Tap Done when finished.
– Wake up: Select the key(s) to press to wake up the device, from Lock
only, Lock or Power or Any Key. Tap Done when finished.
– “X” button: Enable or disable the option of ending of active programs
by tapping the “X” button. Tap Done when finished.
• Align Screen: Run the alignment if the screen is not responding
accurately to stylus taps. Tap Align screen and follow on screen
prompts. Tap Done when finished.
• USB Connection: Select a USB function to determine how the phone
functions when attached to the USB port of a PC
– ActiveSync: Use ActiveSync to interface with your Omnia II. When this
option is active, you can also choose to Enable advanced network
functionality.
– Mass storage: Treats your Omnia II’s memory as a removable drive on
your PC. Select a primary target, either My Storage or an optional install
Storage Card.
Warning!: To safely disconnect your phone from the PC, right-click the
Safely Remove Hardware icon in the PC’s system tray at the
bottom right corner of the PC screen, then click Safely Remove
Hardware. In the dialog, choose your device, then click Stop.
– Data connection: Switch to Data Connection settings. For more
information, see Phone Settings
➔ Data Connection on page 142
• TV Out: Set the TV Out settings:
– Broadcast nation: Select your nation/region.
– Screen ratio: Choose from 4 : 3 or 16 : 9.
– Video quality: Choose from Natural, Sharp, or Soft.
– Brightness: Choose from High, Middle or Low.
– Contrast: Choose from High, Middle or Low.
– Turn off backlight: Select the duration for the backlight.
• DivX Registration: View the DivX registration information. Your Omnia
II is pre-registered, and the registration information may be needed for
some applications.
• GPS: Select the Connection and Location for the GPS application.
– Connection: Select GPS program port. Tap Done when finished.