Samsung SC-DC163-XAP - Manual (Page 3)

15. The apparatus shall not be exposed to dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
16. VENTILATION:
Slots and openings in the cabinet are provided for ventilation
to ensure reliable operation of the CAMCORDER and to
protect it from overheating. These openings must not be
blocked or covered. Never place your CAMCORDER on a
bed, sofa, rug, or other similar surface: on or near a radiator
or heat register. This CAMCORDER should not be placed in a
built-in installation such as a bookcase or rack unless proper
ventilation is provided or the manufacturer’s instructions have
been adhered to.
17. POWER SOURCES:
The CAMCORDER should be operated only from the type of
power source indicated on the label. If you are not sure of the
type of power supply at your home, consult your appliance
dealer or local power company. A CAMCORDER is intended
to be operated from battery power, or other sources, refer to
the operating instructions.
18. GROUNDING OR POLARIZATION:
This CAMCORDER may be equipped with either a polarized
2-wire AC line plug (a plug having one blade wider than the
other) or a 3-wire grounding type plug, a plug having a third
(grounding) pin. If you are unable to insert the plug fully into
the outlet, try reversing the plug. If the plug still fails to fit,
contact your electrician to replace your outlet. Do not defeat
the safety purpose of the polarized plug.
19. POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or
against them, paying particular attention to cords or plugs,
convenient receptacles, and the point where they exit from
the unit.
20. OUTDOOR ANTENNA GROUNDING:
If an outside antenna or cable system is connected to
the CAMCORDER, be sure the antenna or cable system
is grounded to provide some protection against voltage
surges and built-up static charges, Section 810 of the
National Electrical Code, ANSI/NFPA No. 70-1984, provides
information with respect to proper grounding of the mast
and supporting structure, grounding of the lead-in wire and
supporting structure, grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding to conductors, location of
antenna-discharge unit, connection to grounding electrodes
and requirements for the grounding electrode.
See figure below.
Notices and Safety Instructions
ENGLISH
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NEC NATIONAL ELECTRICAL CODE
ELECTRIC
SERVICE
EQUIPMENT
GROUND
CLAMP
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
RainBow_US_Safety.indd 3 2006-02-14 ｿﾀﾈﾄ 8:09:36