Samsung DW80H9950US-AA - Manual (Page 22)

22_ installing the dishwasher
STEP 12 COMPLETING THE INSTALLATION
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you began the installation.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher
is operating. If no errors occur while it is operating, turn off the dishwasher, and then go to
Step 5 below.
If an error has occurred, turn off the dishwasher, close the water supply valve, and then
refer to the user manual or contact a service center 1-800-SAMSUNG (726-7864).
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
5. Locate the sound absorber in front of base refer to the fi gure below (ON SOME MODELS).
Check it the black rubber skirt (*applicable models only) should be located inside, and then
sound absorber will be covered it.
6. Confi rm that the kick plate gasket is on the bottom of the kick plate. To install the kick plate,
refer to the fi gure below.
installing the dishwasher
CAUTION
installation_DW80H9950US-00151A-02_EN_140811.indd Sec3:22 installation_DW80H9950US-00151A-02_EN_140811.indd Sec3:22 2014-08-11 7:39:34 2014-08-11 7:39:34