Samsung HPR5052X-XAP - Manual (Page 14)

¿ P.MODE button
Adjust the TV picture by selecting one of the preset factory settings (or
select your personal, customized picture settings).
¸ S.MODE button
Select Sound effect.
˛ E.SAVING button
Press to adjust screen brightness according to surrounding environment.
(Refer to page 115)
◊ P.SIZE button
Select Picture size.
± DNIe button
Activates DNIe (Digital Natural Image engine).
≠ MTS button
Press to choose stereo, mono or Separate Audio Program
(SAP broadcast).
– SET button
Used during set up of this Samsung remote control, so that it will work
compatibly with other devices (VCR, Cable Box and DVD).
— PIP button
Activates picture in picture.
÷ PIP control buttons
CH , : Displays the available channels in sequence.
(These buttons change channels in the PIP window only.)
® CAPTION button
Controls the caption decoder.
∑ VCR, DVD control buttons
Controls VCR tape or DVD disc functions: Stop, Rewind, Play/Pause,
and Fast Forward.
µ RESET button
If your remote control is not functioning properly, take out the batteries
and press the reset button for about 2~3 seconds.
Re-insert the batteries and try using the remote control again.
14
Installing the Batteries in Your Remote Control
1
Slide the back cover to
open the battery
compartment of the remote
control
.
3
Slide the cover back into
place.
2
Install two AAA size
batteries. Make sure to
match the “+” and “-” ends
of the batteries with the
diagram inside the
compartment.
Remote Control Operation Range
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the TV’s remote control receiver.
BN68-00835A-00(002~035) 4/6/05 8:19 PM Page 14