American Audio DCD-PRO240 - Manual (Page 18)

BASIC OPERATIONS (CONT)
12. FLIP-FLOP™
This feature is a kind of “auto pilot." “Flip-Flop
™
” mode can only function with the both drives of
the DCD-PRO240. The “Flip-Flop
™
” function may be used with or without an American Audio
®
or
American DJ
®
“Q” deck mixer. With “Flip-Flop
™
” you can have one disc drive begin playback when
the other ends. You can “Flip Flop ™ ” single tracks, the entire disc, a combination of the two, or you
can even “Flip-Flop
™
” your programmed tracks.
To FLIP-FLOP ™ single tracks or programmed tracks:
1) Connect your system as described in the set up section on page 6.
2) Set your mixer’s crossfader to the center position.
3) Load disc drives with audio discs.
4) Press and hold the Program button (5), simultanously press the Single button (4). Doing this will
activate Flip-Flop
™
mode. The track numbers on the LCD should be blinking, letting you know
that Flip-Flop ™ mode has been activated.
Figure 18
5) After they have both cued, press the PLAY/
PAUSE BUTTON (14) on one of your drives to
begin playback.
6) After the first cds' single track has ended the
second cds' track will immediately begin play-
back.
7) FLIP FLOP
™
will continue until you stop it or
power is interrupted.
8) To deactivate Flip-Flop
™
mode, repeat step 4.
© American Audio ® - www.AmericanAudio.us - DCD-PRO240™ Instruction Manual Page 18
• When you have finished using the CD unit, and before switching off the power, be sure that the disc
holder has been closed with the OPEN/CLOSE button.
• TRAY PROTECTION: If tray is not closed after 60 seconds, it will close automatically and pause.
CAUTION: DO NOT forcibly close the disc holder when the power is off.
DO NOT switch off the power when the disc holder is
open. Switch off the power after the disc holder has
been closed with the OPEN/CLOSE BUTTON (1).
BEFORE SWITCHING OFF THE POWER
Do not switch off the power
when the disc holder is open. Switch off the power after the
disc holder has been closed
with the OPEN/CLOSE button.