Before calling service, Check the amount of water supplied to the ice tray – Samsung RSG307AABP-XAA User Manual

Page 11

Advertising
background image

English - 11

01 SETTING

UP

Before calling
service

-

Any sounds you hear
when the ice maker
dumps ice into the
bucket are part of
normal operation.

Ice Chute

Ice Chute

-

If you don’t dispense ice for a long period
of time, the ice may form clumps in the
ice bucket. If ice clumps form, remove the
remaining ice and empty the bucket.

-

When ice does not come out, check for ice
stuck in the chute and remove it.

- When Ice Off blinks on the display

panel, reinsert the bucket and/or make
sure it’s installed properly.

-

When the door is open, the Ice and water
dispenser do not work.

-

If you close the door hard, it may cause water
spilling over the ice maker.

-

To prevent dropping the ice bucket, use both
hands when removing it.

-

To prevent injury, be sure to clean up any ice
or water that may have dropped on the floor.

-

Do not let the children hang on the ice
dispenser or on the bucket. They may get hurt.

-

Be sure not to put your hand or any object into
the ice chute. It may cause personal injury or
damage mechanical parts.

Removing residual matter inside the
water supply line after installing fi lter.

1. Turn ON the main water supply.
2. Press the Water button and push the

Dispenser Lever.

3. Flush 1 gallons of water through the filter

before use. (Flush approximately 6 minutes.)
This will clean the water supply system and
remove air from the lines.

4. Additional flushing may be required in some

households.

5. Open the refrigerator door and make sure

there are no water leaks coming from the
water filter.

CAUTION

Ice

Ice

Water

Water

A newly installed water filter cartridge
may cause water to briefly spurt from the
water dispenser. This is due to air getting
into the line. It should pose no problem to
operation.

Check the amount of water supplied

to the ice tray.

1. Lift up the icemaker cover and gently pull it

out.

2. When you press the Test button for 3 seconds,

the ice cube container is filled with water from
the water supply tap. Check to make sure the
amount of water is correct (see the illustration
below). If the water level is too low, the ice
cubes will be small. This is a water pressure
problem from within the main water pipes, not
the refrigerator.

Ice maker

Ice maker

1

1

Test button

Test button

Check the water

Check the water

level

level

2

2

-

It will take a few minutes for the water
to reach the correct level after you push
the Test button.

-

Do not press the test button continuously
when the tray is filled with ice or water. Water
may overflow or ice jamming may occur.

-

When the bucket is not installed, the ice maker
does not work.

-

When Ice Off blinks on the display panel,
reinsert the bucket and/or make sure it’s
installed properly.

CAUTION

DA68-02500A-11.indb 11

DA68-02500A-11.indb 11

2013. 12. 2.

9:48

2013. 12. 2.

9:48

Advertising
This manual is related to the following products: