Samsung RSG307AABP-XAA - Manual (Page 17)

English - 17
02 OPERA
TING
CHANGING THE WATER
FILTER
To reduce risk of water damage to your
property DO NOT use generic brands of
water filers in your SAMSUNG Refrigerator.
USE ONLY SAMSUNG BRAND WATER
FILTERS.
SAMSUNG is not legally responsible for any
damage, including, but not limited to property
damage caused by water leakage from the use of
a generic water fi lter.
SAMSUNG Refrigerators are designed to work
ONLY WITH SAMSUNG Water Filters.
The “Filter Indicator” light lets you know when it is
time to change your water fi lter cartridge. To give
you preparation time to get a new fi lter, the red
light will come on just before the capacity of the
current fi lter runs out. Changing the fi lter on time
provides you with the freshest, cleanest water
from your fridge.
To change the water fi lter, follow these steps:
1. Turn the water
filter 90˚ counter-
clockwise.
2. Pull the water
filter from the filter
housing.
3. Insert new water
filter inside the filter
housing.
4. Turn the new water
filter 90˚ clockwise.
5. Press the “Alarm/hold 3 sec for Filter Reset”
button ( ) for about 3 seconds to reset the
water filter. The color of indicator changes from
red to light off.
WARNING
A newly installed water filter cartridge
may cause water to briefly spurt from the
water dispenser. This is due to air getting
into the line. It should pose no problem to
operation.
Removing residual matter inside the
water supply line after installing a
new fi lter
1. Press the Water button, and then push the
Dispenser Lever with a cup or glass.
2. Flush 1 gallon of water through the filter, one
cup or glass at a time. (Flush approximately
6 minutes.) This will clean the water supply
system and remove air from the lines.
- Additional flushing may be required in some
households.
3. Open the refrigerator door and make sure
there are no water leaks coming from the
water filter.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis
system is less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace
the filter if necessary.
• Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
• If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualifi ed plumber.
Ordering replacement fi lters
To order more water fi lter cartridges, contact your
authorized Samsung dealer.
DA68-02500A-11.indb 17 DA68-02500A-11.indb 17 2013. 12. 2. 9:48 2013. 12. 2. 9:48