Samsung HPP3761X-XAC - Manual (Page 11)

11
1 Remove the screws from the back of the PDP.
2 Connect insulation holders to screws (see the illustration below).
• If you are uncertain about installation, hire a specialist to install the wall mount bracket.
• Be sure to check that the insulation holders are completely secured on both the left
and right side after hanging the PDP on the wall mount bracket.
• Be careful to avoid getting your fingers caught during installation.
• Make sure the wall attachment panels are tightened. Otherwise the PDP may fall.
Note
• A 5 inch(12.7 cm) gap is needed between the back of the Plasma TV and the wall.
Fixing the PDP panel to the wall attachment panel bracket
3 Tighten the screws of the insulation
holders to the back of the PDP. 4 Put the 4 insulation holders on the PDP
in the grooves of the wall mount
bracket and pull down on the PDP (Œ)
to secure it to the wall mount bracket
(´). Tighten the screws as shown (ˇ)
so that the PDP cannot be separated
from wall mount bracket.
PDP panel
Wall attachment
panel bracket
Wall