Samsung HPP3761X-XAC - Manual (Page 9)

¸ SRS TSXT button
Selects TruSurround XT mode.
˛ MTS button
Chooses stereo, mono or Separate Audio Program
(SAP broadcast).
◊ AUTO PROG. button
The TV automatically cycles through all of the
available channels and stores them in memory.
± ADD/DEL button
Adds or deletes channels in the TV’s memory.
≠ DNIe button
Activates DNIe (Digital Natural Image engine).
– CAPTION button
Controls the caption decoder.
— SET button
Used during set up of this Samsung remote control,
so that it will work compatibly with other devices
(VCR, Cable Box and DVD).
÷ PIP control buttons
SIZE : Changes the size of the PIP window.
SWAP : Exchanges the video signal that is
currently displayed on the main screen
with the signal in the PIP window.
CH , : Displays the available channels in
sequence. (These buttons change
channels in the PIP window only).
® VCR, DVD control buttons
Controls VCR tape or DVD disc functions: Stop,
Rewind, Play/Pause, and Fast Forward.
∑ RESET button
If your remote control is not functioning properly, take
out the batteries and press the reset button for about
2~3 seconds. Re-insert the batteries and try using the
remote control again.
9
Installing the Batteries in Your Remote Control
1
Slide the back cover
to open the battery
compartment of the
remote control.
3
Slide the cover back into
place.
2
Install two AAA size batter-
ies. Make sure to match the
“+” and “-” ends of the bat-
teries with the diagram
inside the compartment.
Remote Control Operation Range.
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the PDP’s remote control receiver.