Samsung LT22A350ND-ZA - Manual (Page 98)

◀ ▶ ◀
English
I want to start Anynet+.
• Check if the Anynet+ device is properly connected to the TV and
check if the
Anynet+ (HDMI-CEC) is set to On in the Anynet+
Setup menu.
• Press the TOOLS button to display the Anynet+ menu and select a
menu you want.
I want to exit Anynet+.
• Select View TV in the Anynet+ menu.
• Press the SOURCE button on the TV remote control and select a
non- Anynet+ device.
• Press z and PRE-CH to change the TV mode. (Note that
the channel button operates only when a tuner-embedded Anynet+
device is not connected.)
The message “Connecting to
Anynet+ device...” appears on
the screen.
• You cannot use the remote control when you are configuring
Anynet+ or switching to a view mode.
• Use the remote control after the TV has completed Anynet+
configuration or has finished switching to Anynet+.
The Anynet+ device does not
play.
• You cannot use the play function when Plug & Play (initial setup) is
in progress.