Samsung DV231AGW-XAA - Manual (Page 3)

3
TEST MODE
Service Mode (DV431 only)
How to enter:
-
To enter Service Mode , press Mixed Load Bell + Temp. Keys 3 seconds in normal mode until it
sends out a beeping sound.
- If pressing Mixed Load Bell + Temp. Keys in Service mode , it will return Normal mode.
- Even though entering Service mode, the operating cycle will not be influenced.
DR Ready Modem Wire Test(DV431AS* only)
How to enter:
-
After entering Service Mode, press the Wrinkle Prevent button to start the Wire Test.
- During the test, “----” is displayed.
- If the test result is normal after the test, “SG” is displayed.
- If a problem occurs, the “AE3” error code is displayed.
Touch Sensor Data Display Mode
Definition of Touch Sensor Data Display Mode:
-
This mode is default mode of entering service mode.
How to enter:
-
With Power On pressing Mixed Load Bell +Temp(DV431) or Wrinkle Prevent + Temp(DV231)
for 3 seconds.
- This action will put the dryer into sensor bar touch data mode
- Dryer will display Sensor Bar data.
Cycle Count Mode
Definition of Cycle Count Mode:
-
This mode is to bring up the total number of cycles that User have carried out.
How to enter:
-
Press the Mixed Load Bell(DV431) orTime(DV231) key in Service Mode.
Software Revision Mode
Definition of Software Revision Mode:
-
It is to retrieve its software version
How to enter:
At Service Mode, press Temp until it sends out a beeping sound
ex) In case of “U1 05”, U1 means major version “U1”, 05 means minor version “05”.
-
If press Temp key In Software Version Mode, it will return Service Mode.
ALIGNMENT AND ADJUSTMENTS
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
(Technical)DV431AEP-02365D-03_EN.indd 3 2012-04-26 �� 10:42:54