Setting up your side-by-side refrigerator, Setting up the refrigerator, Installing the handles – Samsung RS267TDWP-XAA User Manual
Page 12
12_
setting up
setting up your side-by-side refrigerator
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
rce or try the troubleshooting section at the back of
this user’s guide. If you have any further questions, contact your Samsung Electronics service center.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control [Refer to ‘Freezer/Fridge(Temperature adjustment)’, page 23] to the coldest
temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is su ciently cool.
5. Assemble the water line to the refrigerator and verify that the couplers are correctly assembled without
water leakage. (Refer to ‘Installing the water line’, page 20)
Check the accessory list below.
Installing the handles
1.
.
r
o
o
d
e
d
i
s
t
h
g
ir
e
h
t
m
o
rf
t
u
o
s
e
l
d
n
a
h
e
h
t
e
k
a
T
The handles are included in the package.
Hex wr ench
Compr
Compression nut
ed)