Samsung HT-A100T-XAA - Manual (Page 52)


troubleshooting
SYMPTOM Check/remedy
• Disc is rotating but no
picture is produced.
• Picture quality is poor and
picture is shaking.
• Is the TV power on?
• Are the video cables connected properly?
• Is the disc dirty or damaged?
• A poorly manufactured disc may not be playable.
Audio language and subtitles do
not work. • Audio language and subtitles will not work if the disc does
not contain them.
Menu screen does not appear
even when the menu function is
selected. • Are you using a disc that does not contain menus?
Aspect ratio cannot be changed. • You can play 16:9 DVDs in 16:9 WIDE mode, 4:3 LETTER
BOX mode, or 4:3 PAN SCAN mode, but 4:3 DVDs can be
seen in 4:3 ratio only. Refer to the DVD disc jacket and then
select the appropriate function.
• The main unit is not working.
(Example: The power goes out
or strange noise is heard.)
• The DVD player is not working
normally.
• Turn off the power and hold the STOP (@) button on the
remote control for longer than 5 seconds.
Using the rESET function will erase all stored settings.
Do not use this unless it is necessary.
The password for rating level has
been forgotten. • While “NO DISC” message appears on the display of main
unit, hold the main unit's STOP (@) button for longer than 5
seconds. “INITIAL” appears on the display and all settings will
return to the default values.
• Press the POWER button.
Using the rESET function will erase all stored settings.
Do not use this unless it is necessary.
Can't receive radio broadcast. • Is the antenna connected properly?
• If the antenna's input signal is weak, install an external FM
antenna in an area with good reception.
02056S-HT-A100-XAC-ENG.indd 52 2008-03-18 �� 11:57:11