Samsung LS17TRTLSY-XAA - Manual (Page 63)

on the monitor
blinking at 1 second
intervals? and restore the image on the screen.
If there is still no image, press the 'SOURCE' button.
Then press any key on the keyboard again to activate
the monitor and restore the image on the screen.
I cannot see the On
Screen Display. Have you locked the
On Screen Display
(OSD) Menu to
prevent changes? Unlock the OSD by pressing the [
] button for at least 5
seconds.
The screen shows
strange colors or
just black and white. Is the screen
displaying only one
color as if looking at
the screen through a
cellophane paper? Check the signal cable connection.
Make sure the video card is fully inserted in it's slot.
Have the screen
colors become
strange after running
a program or due to
a crash between
applications? Reboot the computer.
Has the video card
been set properly? Set the video card by referring to the video card
manual.
The screen
suddenly has
become
unbalanced. Have you changed
the video card or the
driver? Adjust screen image position and size using the OSD.
Have you adjusted
the resolution or
frequency to the
monitor? Adjust the resolution and frequency at the video card.
(Refer to the
Preset Timing Modes ).
The screen can be unbalanced due to the cycle of the video card signals.
Readjust Position by referring to the OSD.
The screen is out of
focus or OSD
cannot be adjusted. Have you adjusted
the resolution or
frequency on the
monitor? Adjust the resolution and frequency of the video card.
(Refer to the
Preset Timing Modes ).
LED is blinking but
no images on the
screen. Is the frequency
properly adjusted
when checking the
Display Timing on
the menu? Adjust the frequency properly by
referring to the video card manual
and the
Preset Timing Modes .
( The maximum frequency per
resolution may differ from product
to product. )
There are only 16
colors shown on the
screen. The screen
colors have
changed after
changing the video
card. Have the Windows
colors been set
properly? Windows XP :
Set the resolution at the Control Panel → Appearance
and Themes → Display → Settings.
Windows ME/2000 :
Set the resolution at the Control Panel → Display →
Settings.
Has the video card
been set properly? Set the video card by referring to the video card
manual.
There is a message
that reads
"Unrecognized
monitor, Plug & Play
(VESA DDC)
monitor found". Have you installed
the monitor driver? Install the monitor driver according to the Driver
Installation Instructions .
See the video card
manual to see if the
Plug & Play (VESA
DDC) function can
be supported. Install the monitor driver according to the Driver
Installation Instructions .